MTAK-1 Standard Mounting Bracket Kit
The MTAK-1 Standard Mounting Bracket Kit is supplied as standard with all multi-sensor Probes. It is made from 2.5 mm 316 stainless steel. The MTAK-1 Standard Mounting Bracket Kit includes a built-in integral squeegee, stainless steel hook, mounting screws, wall plugs and cable ties.
MTAK-2 Extended Mounting Bracket Kit
The MTAK-2 Extended Mounting Bracket Kit is optional and only supplied on order. It is made from 2.5 mm 316 stainless steel. The extended bracket can be used with all multi-sensor Probes and provides a greater swing area. The MTAK-2 Extended Mounting Bracket Kit includes a built-in integral squeegee, stainless steel hook and cable ties.
Installation
Installation
The MultiTrode Probe is designed to be supported on its cable from the suspension/cleaning bracket. It is desirable for the Probe to be located near the inflow in a reasonably turbulent area of the wet well. The inflow should not be allowed to run directly onto the Probe, but the surface agitation of the inflow area helps to keep the Probe clean. Before choosing a Probe location, the wet well should be pumped down as far as possible. Suspend the Probe from its approximate position to ensure that adequate clearance exists from objects in the pit. A minimum of 300 mm clearance should be maintained from any conductive surfaces.
Mounting
To mount the Probe, thread the cable through the stainless steel hook. Place the hook in the mounting bracket or eye-bolt and adjust the cable length until the bottom of the Probe is 10 mm above the minimum liquid level. Fasten the cable to the hook using cable ties. Draw the loose end through the conduit to the control panel.
Cleaning
Provide sufficient slack in the cable to allow the Probe to be drawn through the cleaning bracket or taken out of the well for cleaning. MultiTrode Probes are designed to greatly reduce, if not eliminate, cleaning. This is achieved by correctly positioning the Probe and selecting sensitivity on the level controller.
|
